Shure SM86

Transducer Type

Condenser (electret bias)

Frequency Response
50 to 18,000 Hz

Polar Pattern
Cardioid

Output Impedance
150 Ohms at 1 kHz
Recommended minimum load impedance: 600 Ohms

Sensitivity (at 1,000 Hz)
Open Circuit Voltage: -50 dBV/Pa (3.15 mV)
(1 Pa = 94 dB SPL)

Output Clipping Level
1000 Ohm Load at 1,000 Hz: +3 dBV (1.41 V)

Maximum SPL (at 1,000 Hz)
1000 ohm load (1% THD): 147 dB

Self-Noise
23 dB typical, A-weighted

Dynamic Range (1000 ohms)
124 dB (maximum SPL to A-weighted noise level)
Signal-to-Noise Ratio

71 dB at 94 dB SPL (IEC 651)*
*S/N ratio is difference between 94 dB SPL and equivalent SPL of self-noise A-weighted.

Polarity
Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of the output connector.

Power
Phantom Supply Requirement: 11 to 52 Vdc, positive at both pins 2 and 3
Current Drain: 5.2 mA

Connector
Three-pin (XLR) professional audio

Case
Dark gray enamel-painted steel with matte-finished silver colored steel grille

Dimensions
See User Guide

Net Weight
Net: 278 grams (9.8 oz)

Environmental Conditions
Operating: -18 degrees to 60 degrees C (0 degrees to 135 degrees F) (relative humidity >90%)
Storage: -29 degrees to 74 degrees C (-20 degrees to 165 degrees F) (relative humidity >80%)